Start-Up; Inserting Batteries; Setting The Remote Control; Operating Other Loewe Devices - Loewe SoundBox Instrucciones De Manejo

Loewe SoundBox
Instructions for Use

Start-up

Assist remote control

Inserting batteries

To insert or replace the batteries, press on the point marked with the
arrow. While doing so, simply slide the battery compartment lid down
and remove it. Insert alkaline manganese batteries LR 03 (AAA) and
ensure the correct position of + and –. Slide the cover on again from
the bottom.

Setting the remote control

Other devices
You can operate various Loewe devices using the Assist remote control.
The unit buttons REC - DVD - AUDIO can be set for this.
Press the required unit buttons and the Stop button
simultaneously for 5 sec. until the corresponding LED
indicator light flashes twice.
Then select the two-digit unit code from the table:
Unit
Loewe ViewVision 8106 H
Loewe Viewvision, Centros 21x2
Loewe ViewVision DR+ DVB-T
Loewe Auro 2216 PS/8116 DT
Loewe BluTechVision
Loewe Soundprojector 1
Loewe TV Radio digital
Loewe Mediacenter
Loewe BluTechVision Interactive
HDMI CEC Modus
Loewe AudioVision
Loewe Sound Projector SL
Apple
Apple TV
SoundBox
SoundVision
Air Speaker
Restore defaults
The corresponding LED indicator light flashes twice.
- 20 - - 20 -
Code Factory setting
10
12
REC
13
14
15
17
19
20
21 DVD
22
24
25
26
27
AUDIO
28
29
30
99

Operating other Loewe devices

Using the remote control for the Loewe SoundBox
Press the AUDIO button, the LED indicator lights up
for about 5 seconds
Using the remote control for a Loewe TV set
Press the TV button, the LED indicator lights up for
about 5 seconds
Using the remote control for a Loewe recorder
Press the REC button, the LED indicator lights up for
about 5 seconds
Using the remote control for a Loewe DVD player
Press the DVD button, the LED indicator lights up for
about 5 seconds
Every time a button is pressed, the LED indicator lights up for the se-
lected operating mode to allow you to check (TV – REC – DVD – AUDIO).
Please refer to the respective operating instructions on how to operate
the individual devices.

Connecting to the mains supply

Make the required cable connections as shown in the section "Connec-
tion" (page 19). Plug the mains plug into the mains socket 230V 50 Hz.

Switching on/off

Set the remote control for SoundBox operation by
pressing the AUDIO button briefly.
Your SoundBox switches on.
The LED indicator light above the ON/OFF button
18 lights up.
To switch off the unit, press the ON/OFF button
on the SoundBox or on the Assist remote control again.
➠
If you will be absent for some time, first switch off
the unit with the ON/OFF button and then pull out
the mains plug. You can thus save energy and protect
the environment.
➠
The unit switches off automatically after 60 minutes
without playback in the operating mode CD or USB
(into Standby Mode) in order to save energy (page
24).
➠
The unit switches automatically off after 4 or 8
hours (into Standby Mode) in order to save energy
(page 24).
18