Lock Function - Monacor JTS IN-264TB/5 Manual De Instrucciones

5.1.5 Lock function

When the lock function has been activated, you will
no longer be able to switch off the transmitter. From
the setting modes, you will only be able to activate
the mode for the lock function in order to deactivate
the lock. When the transmitter is locked and you set
the on / off switch (2) to OFF or press a button, the
display will show
Note: Do not leave the on / off switch in the position OFF
when the transmitter is locked; the display backlight will not
be extinguished automatically and there will be unneces-
sary power consumption.
Activating the lock
1) Keep the button SET (4) pressed until the dis-
play briefly shows
ting mode (group indication starts flashing).
2) Press the button SET repeatedly until the dis-
play shows
3) To activate the lock, press the button + (6). The
display shows
4) Press the button SET to confirm. The display
briefly shows
normal mode.
Deactivating the lock
1) Make sure that the on / off switch (2) is set to ON.
2) Keep the button SET (4) pressed until
flashing in the indication
3) To deactivate the lock, press the button – (5).
The display shows
4) Press the button SET to confirm. The display
briefly shows
normal mode.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
(lock on).
and then the group set-
(lock off).
.
. The unit will return to the
.
.
. The unit will return to the
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
6 Specifications
Carrier frequency range: . . 506 – 542 MHz
Frequency stability: . . . . . . ±0.005 %
Transmission power: . . . . . 10 mW
Audio frequency range: . . . 40 – 18 000 Hz
Ambient temperature: . . . . 0 – 40 °C
Power supply: . . . . . . . . . . 2 × 1.5 V battery of
Operating time: . . . . . . . . . > 25 h (for alkaline
Dimensions: . . . . . . . . . . . 68 × 172 × 21 mm
Weight: . . . . . . . . . . . . . . . 77 g (w/o batteries)
Microphone connection: . . mini XLR, 4 poles
1 = ground
2 = 5 V operating voltage for the microphone
3 = signal input
4 = impedance correction
Lavalier microphone CM-501 supplied
Type/directivity: . . . . . . . . . electret microphone /
Frequency range: . . . . . . . 100 – 15 000 Hz
Sensitivity, impedance: . . . 3.2 mV/Pa at 1 kHz,
starts
SPL max.: . . . . . . . . . . . . . 130 dB
Power supply: . . . . . . . . . . via pocket transmitter
Weight: . . . . . . . . . . . . . . . 20 g
Subject to technical modification.
table on page 21
size AA (not supplied)
batteries 3400 mAh)
cardioid
2.2 kΩ
11