Basic Functions - Team Electronic TeCom-IP Serie Instrucciones De Uso

English

BASIC FUNCTIONS

Antenna
Due to governmental regulations, with the PMR version the antenna is fixed, i.e. non-
detachable. All other versions have a detachable antenna. To mount antenna, place
the antenna-base onto the connection thread at the top of the radio, and turn tight in
clockwise direction.
For detachment, turn the antenna at the base - not at the tip - counterclockwise.
Battery Pack
To mount the battery pack (11) onto the radio, place the grooves at the top of the battery
pack onto the battery compartment of the radio-case and push the battery pack into final
position. Then close the latch and push it until it locks in.
To remove the battery pack, open the lock (9) by pulling the closure, which is labeled
OPEN, with your index finger.
Charging
Prior to first use, the battery pack (11) has to be fully charged. A complete charging
cycle takes approximately 6 hours.
Connect the cable of the power supply with the base of the charger before connecting
with a 220 V plug. The LED shorty lights up red and then green. Now, place the radio
with the attached battery pack (11) into the charger. Pay attention to proper place-
ment. During the charging process, the LED lights red.
Once charging is completed, the LED lights green. Take the radio out of the base.
Overcharging reduces the battery pack's longevity.
On / Off
To switch on the radio, turn the combined on/off-volume switch (5) clockwise beyond
the barrier. If the warn tone and the voice annunciation are activated, a beep tone is
emitted and the actual channel number is announced.
To switch off the radio, turn the on/off-volume knob (5) counterclockwise beyond the
barrier.
Volume Control
Use the combined on/off-volume knob (5) for volume control. Turning clockwise in-
creases the volume level and turning counterclockwise reduces it.
To set a comfortable volume level after turning the radio on, hold the function key (8) -
key has to be programmed with the monitor function - while adjusting the volume level
with the combined on/off-volume switch (5).
Note:
The function key (8) can be programmed via software with one of these functions: mo-
nitor, tx-power high/low and alarm.
16
Channel Selection
For channel selection use the channel selector (5). If the warn tone and the voice an-
nunciation are activated, a beep tone is emitted and the actual channel number is an-
nounced once the channel has changed.
Note:
The scan function operates on channel 16. If scan is enabled, channel 16 is no longer
available for radio communication.
If no frequency is programmed on the selected channel, a constant warn tone is audible.
Transmit
For transmission hold the PTT key (7) until the end of the message.
For best sound quality, talk into the microphone (3) at a middle volume level at a di-
stance of approximatly 10 cm. During transmission the control LED (6) lights red.
Upon release of the PTT key (7) the radio returns automatically into reception mode.
Once a signal is present on the selected frequency, the LED lights green.
Reception
Once a signal is present on the selected frequency, the LED lights green.
Note:
If the selected frequency is decoded with a CTCSS-/DCS-code, all signals that are
encoded with a different code will be muted. The green LED will light but no signal will
be audible.
English
17