Publicidad
Idiomas disponibles
Idiomas disponibles
MACHINE OPERATION – BASICS
Description of the device
6
5
4
1
3
2
Control panel description
2
3
1
5
4
Before using the device, unpack and assemble it. The shelves are fitted using special hooks. Remember to
install the hooks in such a way that the shelves rested on them evenly and steadily. After installing the shelves,
clean the device thoroughly.
NOTE: Before putting any foodstuffs into the fridge, turn it on, close it and let it run empty for an hour.
Using the device
In order to select the correct temperature, press and hold the Set button for about 5 seconds; when the
display shows „Se", press the Set button again. Next, use the buttons marked as 3 and 4 in the photo to
choose the desired temperature. In order to exit the temperature setting mode, press the button marked as
5 in the photo, or wait about 30 seconds for the device to automatically return to the current temperature
display. The device maintains the pre-set temperature automatically.
In order to defrost the fridge, hold the button marked with 5 for about 3 seconds. The display will show
the symbol „def" and letters „De". In order to stop defrosting, once again hold the button marked as 5 for
about 3 seconds until the "def" symbol disappears and the display shows the current temperature. You can
also defrost the fridge by unplugging it from the power source. The fridge defrosts automatically. Condensed
water precipitates into a special tray located on the compressor and evaporates.
10
1.
Adjustable height shelves
2.
Temperature regulator
3.
Lock, the exact location depends on the mode
4.
Door opening handle (depending on the model the
door can be sliding or hinged)
5.
Slats holding the shelves
6.
Backlit banner (for RCGK-600C)
1.
LED display
The display shows the temperature
and individual functions of the
device
2.
Set
Used to set temperature
Parameter adjustment
3.
Light, temperature up
Used to turn the illumination
on/off
Used to pre-set the temperature
4.
Temperature down
Used to reduce the temperature
5.
Back/exit
Used to leave the setup mode
Hold to defrost
Rev. 24.05.2017
Lighting
In order to switch on the light inside the fridge, press the button marked with a 3; in order to switch the
light off, press this button again. The RCGK-600C is equipped with a backlit advertising banner. The switch is
activated by means of a switch on the side of the backlit banner (externally mounted).
TRANSPORTATION AND STORAGE
During transport, the machine should be protected from shaking, falling and turning upside down. Store it in
a properly ventilated place with dry air and without any corrosive gas.
CLEANING AND MAINTENANCE
•
Always unplug the device before cleaning it and after each use.
•
Use cleaner without corrosive substances to clean surface.
•
After cleaning the device, all parts should be dried before reusing it.
•
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
•
Never spray the device with water jets.
CHECK REGULARLY THE DEVICE
Regularly check the machine for signs of damage. If the machine is damaged, please stop using it immediately
and contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare the following information:
•
Invoice number and serial number (the latter is to be found on the technical plate on the device).
•
If relevant, take a picture of the damaged, broken or defective part.
•
It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. The more detailed your information, the better
customer service will be able to solve your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
Rev. 24.05.2017
11
Publicidad
