Identification Number - Roger Technology H70/200AC Instrucciones Y Advertencias Para El Instalador

Clock contact configuration
When the clock function is active, the gate opens and remains open.
At the end of the programmed time set with the external device (clock), the gate closes.
When the clock function is active, the gate opens and remains open. Any command signal received is ignored.
When the clock function is active, the gate opens and remains open. Any command signal received is accep-
ted. When the gate returns to the completely open position, the clock function is reactivated.
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
+
P1
P2
-
Warning! Restoring default settings cancels all settings made previously: after restore, check that all param-
eters are suitable for the installation.
The default factory settings may also be restored using the + (PLUS) and/or - (MINUS) buttons as follows:
• Turn off the power.
• Press and hold the + (PLUS) and - (MINUS) buttons until the unit switches on.
• The message flashes on the display after 4 s.
• The default factory settings have now been restored.
Identification number
The identification number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
HW version.
Year of manufacture.
Week of manufacture.
Serial number.
FW version.
View manoeuvre counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvres performed.
Example: x100 = 12.300 manoeuvres.
View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvre hours.
Example: = 123 hours.
View control unit days on counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Days with unit switched on.
Example: = 123 days.
x4 s
to .
Example:
to multiplied by 100.
to .
to .
71