Tabla de contenido
Publicidad
2. GETTING STARTED SEWING
LEVELING MACHINE
CHECKING
Put the machine on a flat table.
Check the balance of the machine.
ADJUSTMENT
Lay machine on its back gently and carefully with both hands.
Be careful not to make scratches on both machine and table.
Be careful not to drop the machine and not to have your
fingers be caught between the machine and table.
Insert the driver into the hole (1) and adjust by turning it.
* Use screwdriver (small) included in the accessories.
Check the balance of the machine after adjustment.
SETTING UP MACHINE
Be sure to wipe off any surplus oil from needle plate area
before using your machine the first time.
POWER LINE CORD/FOOT CONTROL
Connect the plug of the power line cord into the cord
socket (1) and your wall outlet (2) as illustrated.
Connect the foot control plug into the machine socket (3),
when using sewing machine only.
NOTE: When foot control is disconnected, the machine
will not operate.
Always disconnect the machine from power
supply by removing the plug from the wall-
outlet.
POWER/LIGHT SWITCH
Your machine will not operate until the power/light switch
is turned on. The same switch controls both the power and
the light.
When servicing the machine, or changing needles or
Iamps, etc., machine must be disconnected from the
power supply.
Power/light switch "OFF"
Interrupteur moteur/lumière "OFF"
Interruptor corriente/luz "OFF"
10
(1)
Set power/light switch at
"OFF"
Mettez l'interrupteur moteur/
lumière sur "OFF".
Poner el Interruptor de corriente/
luz de velocidad en "OFF"
Machine socket
Connecteur de la
machine
Conector de la máquina
Pin
Butée
Pasador
3
1
Power line cord
Cordon
Cordón de la linea eléctrica
Foot control
Rhéostat
Control por pedal
Power/light switch "ON"
Interrupteur moteur/lumière "ON"
Interruptor corriente/luz "ON"
2
Publicidad
Tabla de contenido
