Inserting Zippers And Piping; Hand-Look Quilt Stitch; Straight Stitch With Auto Tie-Off Function - Singer CE-250 Manual De Instrucciones

INSERTING ZIPPERS AND PIPING

Use the zipper foot to sew to the right or left of the zipper or to
sew close to a cord.
INSERTING ZIPPERS
To sew down the right side, attach left side of zipper foot to
presser foot holder so that the needle passes through the
opening on the left side of the foot.
To sew down the left side, attach right side of foot to foot
holder.
PIPING
Create a piping by covering a filler cord with a bias strip of fabric.
Attach the right side of the zipper foot to the foot holder so that
the needle passes through the right side of the zipper foot.
Baste the seam allowances together, enclosing the filler cord,
forming seam tape for the piping.
Helpful Hint: Slight adjusting of the needle position to
sew closer to the piping may be accomplished with
the Stitch Width Control.

HAND-LOOK QUILT STITCH

This stitch is designed to look like hand sewing for topstitching
and quilting.
1. Thread bobbin with desired top stitching color.
2. Thread machine with invisible thread or same color thread,
which matches fabric, so it doesn't show.
3. Increase thread tension toward 6 or higher until you
achieve the desired appearance.
4. Set the stitich length at 4 (maximum).
5. Start to sew.
NOTE: When the upper thread is loose, the machine may
stop in the beginning.
If the machine stops from the beginning, push the start
switch again.
STRAIGHT STITCH WITH AUTO
TIE-OFF FUNCTION
1. Press the foot control and the machine will sew 4 stitches
in forward and then 4 stitches in reverse and continue to
sew in forward until the foot control is released.
2. Push the reverse switch and the machine will sew 4
stitches in reverse and then 4 stitches in forward and stop.
38
Needle to left of foot
Aiguille à gauche du pied presseur
Aguja a la izquierda del
prensatelas
Needle to right of foot
Aiguille à droite du pied presseur
Aguja a la derecha del
prensatelas