Publicidad
Idiomas disponibles
Idiomas disponibles
FUEL HANDLING
Gasoline
Fuel safety
Never start the machine:
1. If you have spilled fuel on it. Wipe off the
spillage and aIIow remaining fuel to evapo-
rate.
2. If you have spilled fuel on yourseIf or your
clothes, change your clothes. Wash any
part of your body that has come in contact
with fuel. Use soap and water.
3. If the machine
is leaking fuel. Check regu-
larly for leaks from the fuel cap and fuel
_ines.
Transport
and storage
• Store and transport
the machine
and fuel
so that there is no risk of any leakage or
fumes
coming into contact with sparks
or
naked flames,
for example,
from electri-
cal machh_ery, e_ectric motors, electrical
relays/switches
or boilers.
• When
storing and transporting
fue_ al-
ways
use approved
containers
intended
for this purpose.
• When storing the machine
for long peri-
ods the fuel tank must be emptied.
Con-
tact your local gas station to find out
where to dispose
of excess
fuel.
• Ensure the machine
is cleaned and that
a complete
service
is carried out before
tong-term
storage.
• The transport
guard must always
be
fitted to the cutting
attachment
when the
machine
is being transported
or in stor-
age.
• In order to prevent unintentional
starting
of the engine, the spark
plug cap must
always
be removed during
long-term
storage,
if the machine
is not under
close supervision
and when performing
all service
measures.
_lb
ARNING:
Take care when han-
dling fuel. Bear in mind the risk of
fire, explosion
and inhaling fumes.
Fuel
CAUTION!
The machine is equipped with a
two-stroke
engine and must always be run
using a mixture of gasoline and two-stroke
engine oil. It is important to accurately
mea-
sure the amount of oil to be mixed to ensure
that the correct mixture is obtained. When
mixing small amounts of fuel, even small
inaccuracies
can drastically affect the ratio
of the mixture.
l_i
ARNING:
Fuel and fuel fumes
are highly inflammable
and can
cause serious
injury when inhaled
or allowed
to come in contact
with
the skin, For this reason
observe
caution when
handling fuel
and
make sure there
is adequate
ven-
tilation.
CAUTION!
Always use high quality
unleaded
gasoline.
• This engine
is certified
to operate
on
unleaded
gasoline.
• The lowest recommended
octane rating is
87. If you run the engine on lower octane
rating than 87, "knocking" can occur. This
leads to an increased engine
tempera-
ture, which can result in a serious engine
breakdown=
• When working
at continuous
high revs, a
higher octane rating is recommended.
Two-stroke
oil
• For best results
and performance,
use
HUSQVARNA
two-stroke
oil, which is
specially
formulated
for our two-stroke
engines.
Mixture
1:50 (2%).
• To maximize
the life of your trimmer, you
may choose
to use a high quality syn-
thetic oil formulated
for two-stroke
engines.
Mixture
1:50 (2%).
• Never use two-stroke
oil intended for
water-cooled
outboard
engines,
sometimes
referred to as outboard
oil.
• Never use oil intended for four-stroke
engines.
Gasoline
U.S. gallon
1
21/2
5
Two-stroke
oil
2% (1:50)
U.S. fl. oz,
2 1/2
61/2
t2 7/8
Publicidad
