WALTHER PILOT PILOT III F Instrucciones De Servicio página 12

Contents
Exploded Drawing
Declaration of CE-Conformity
Replacement parts
1 General
1.1 Identification of Model Version
1.2 Normal Use
1.3 Improper Use
2 Safety Instructions
2.1 Identification of safety instructions
2.2 General Safety Instructions
3 Technical Description
4 Connection of Input Lines
5 Operational Handling
6 Adjusting the Spray Pattern
6.1 Correcting the Spray Pattern
7 Troubleshooting and fault rectification
8 Replacement of the Spray Gun Components
8.1 Replacement of material nozzle and air cap
8.2 Replacement of the needle
8.3 Replacement of needle seal packing
9 Cleaning
10 Waste disposal
11 Technical Data
2
23
24
28
28
28
29
29
29
30
30
31
32
33
33
34
34
34
35
35
35
36
36
22
Declaration of CE-Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility that the
product(s) described below conform to the essential safety requirements. This declaration will be
rendered invalid if any changes are made to the equipment without prior consultation with us.
Manufacturer WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type Designation Manual Spray Guns PILOT III F / -MP / PILOT III K
PILOT III F
PILOT III F
PILOT III F
PILOT III F-MP
PILOT III F-MP
PILOT III K
PILOT III K
Intended purpose Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006 / 42 / EC
94 / 9 EC (ATEX Directives)
DIN EN ISO 12100-1
DIN EN ISO 12100-2
EN 1127-1
Specification according 94 / 9 / EC
Category 2 Part marking
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30
D- 42327 Wuppertal
Special remarks :
The named product is intended for installation in other equipment. Commissioning is prohibited
until such time as the end product has been proved to conform to the provision of the Directives
2006 / 42 / EC.
Wuppertal, the 1st of January 2010
i.V.
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety instructions
provided in the product documentation must be observed at all times.
Gravity-Feed Cup V 10 301
Material Connection V 10 302
Syphon-Feed Cup V 10 303
Gravity-Feed Cup V 10 310
Material Connection V 10 311
Gravity-Feed Cup V 10 351
Material Connection V 10 352
DIN EN 1953
DIN EN 13463-1
Tech.File,Ref.:
II 2 G c T 6
2403
23