Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
02 ENG_Paddle_8830_0108
ENGLISH
Screw the clamping nut (12) or the Quick
clamping nut (11) onto the spindle. Lock the
spindle in position. Secure the cup-grinding wheel
with the clamping nut (12) or the Quick clamping
nut (11).
Use the offset pin spanner (n) if the clamping nut
(12) is being used.
Set the cup-grinding wheel/wheel guard projec-
tion as required (approx. 0.5 - 1 cm/0.2" - 0.4").
Slacken off the two wing screws and adjust the
wheel guard evenly upwards or down. Retighten
wing screws.
14 Repairs
Repairs to power tools must be carried
out by a qualified electrician only.
Any Metabo power tools in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please send the tool for repair with a brief
description of the fault identified.
15 Environmental Protection
Metabo packaging is 100% suitable for recycling.
Power tools and accessories at the end of their
service life still contain large amounts of valuable
raw materials and plastics which can likewise be
fed back into a recycling process.
As the dust generated during grinding/cutting may
contain harmful materials, do not dispose of it
along with domestic waste but ensure it is taken
to a collection point for special waste for proper
disposal.
These Operating Instructions are printed on paper
produced in a chlorine-free bleaching process.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline
2002/96/EC on used electronic and electric
equipment and its implementation in national
legal systems, used power tools must be
collected separately and handed in for
environmentally compatible recycling.
20
22.01.2008
11:24 Uhr
Seite 20
16 Technical Specifications
Notes on the details on page 2.
We reserve the right to undertake modifications to
reflect technical advances.
D
= maximum grinding disc diameter
max
n
= no-load speed
M
= spindle thread
P
= rated input
1
P
= output power
2
a
= typically rated acceleration in the
hw
hand-arm area
Typical A-rated acoustic level:
L
= acoustic pressure levell
pA
L
= acoustic power level
WA
Wear ear protectors!
m
= weight
Measured values established according to
EN 50144.
The stated technical specifications are subject to
tolerances (as specified in the respective current
standards).
Publicidad
Capítulos
Tabla de contenido
