Descargar Imprimir esta página

Switching On And Off - Triton TA235CSL Instrucciones De Funcionamiento Y Seguridad

Ocultar thumbs Ver también para TA235CSL:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 85
width setting, the thumb screw can be
repositioned to the inner or outer clamp
location.
SIGHTING NOTCHES
1. Two sets of sighting notches at the front of the
base plate provide guidance when performing
free-hand cuts following a pencil line.
2. When viewed from the front of the saw
use the left hand side notch for 90° cuts
and the right hand sight notch for 45°
cuts. Sight along either edge of the notch,
Use left notch
for 90˚ cuts
depending on which side of the line you
wish to cut.
3. Use the second set of notches, closer to
the saw blade, to confirm the alignment
of your saw during the cut.

SWITCHING ON AND OFF

1. Connect the plug to the power supply.
2. To switch on the saw, press down the
lock-off button (4) and whilst holding
down the lock-off button press down the
trigger switch (3).
3. When you release the trigger, the saw
Use right notch
for 45˚ cuts
turns off and the lock-off button re-
engages. You will need to press down the
lock-off button again to turn the saw on.
Allow the blade to come to a complete
standstill before setting the saw down.
USING THE LASER SYSTEM
• Do not stare directly at the laser beam.
• Never aim the beam at any person or an
object other than the workpiece.
• Do not deliberately aim the beam at
personnel and ensure that it is not
directed towards the eye of a person for
longer than 0.25s.
• Always ensure the laser beam is aimed
at a sturdy work piece without reflective
surfaces. I.e. wood or rough coated
surfaces are acceptable. Bright shiny
reflective sheet steel or the like is not
suitable for laser use as the reflective
surface could direct the beam back at the
operator.
• Only turn laser beam
on when tool is
on workpiece.
1. Mark the line of the
cut on the workpiece.
2. Adjust the depth of
cut and bevel angle as
required.
3. Rest the front edge of the base on the
workpiece.
4. Switch on the laser beam by pressing the
laser sight on/off switch (2).
5. Line up the laser line with the pencil line
on the workpiece.
6. Start the motor by squeezing the trigger
switch (3).
7. Make your cut ensuring that the laser line
is kept in line with the pencil line.
GB
Adjustments
11

Publicidad

loading