Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Packaging Contents
• 1 x GS 490 glass luxury scale
• 1 x 3 V Battery CR2032
• 1 x Instruction manual
4. Before First Use
1. Remove the Battery Isolator Strip that protrudes from the Battery Compartment. When
"Lo" appears in the LCD Display, replace the battery with one CR2032 button cell battery.
2. Place the scale on a hard, level floor (no carpeting or rugs); a hard surface is required
for accurate measurement.
3. Before first use or after moving the scale, reset the scale to true zero by performing
the following steps:
a. Step onto the scale for one second to activate the LCD Display, then quickly step off.
b. The LCD Display will show "0.0 lb" (or kg/st as selected).
c. After a few seconds, the LCD Display will shut off.
d. You can now use the scale, as described in the "To Use" section below.
5. To Use
1. Tap your foot on the scale to activate it and then press the Weight Selector Button, located underneath
the scale next to the Battery Compartment, to select pounds (lb), kilograms (kg), or stones (st) in the
LCD Display. Results are shown in increments of 0.2 lb/ 0.1 kg/ 0.1 st.
2. Place the scale on a flat, level, hard surface to ensure accurate measurement.
3. Carefully step onto the scale, stand still, and distribute your weight evenly on both feet.
4. After a few seconds, the scale will stabilize and your weight will flash on the LCD Display. Step off the
scale; the LCD Display will shut off after about 10 seconds.
6. Care and Maintenance
• Clean the scale with a damp cloth and a mild detergent. Do not immerse the scale in water or rinse it
under running water.
• Store the scale in a cool, dry place when not in use; ensure no objects are placed on the scale during
storage.
Disposal
Observe the local regulations for material disposal. Dispose of the device in accordance with local regulations.
If you have any questions, please contact the local authorities responsible for waste disposal.
7. Troubleshooting Guide
Error
Possible Cause
O-Ld
Capacity of 400 lb (181.4 kg / 28.5 st) exceeded. Do not exceed maximum weight.
Lo
Low Power
No display
Batteries are depleted or inserted incorrectly.
Scale
Scale placed on soft surface or movement took
shows unre-
place during measurement.
alistic result
Solution
Replace battery
Replace batteries and ensure correct
polarity.
• Wait until scale switches off automati-
cally and repeat measurement.
• Place the scale on hard surface (no car-
peting or rugs).
• Stand still during measurement.
4
Publicidad
Tabla de contenido
