First Startup (Autoconfiguration) - Gruppo Ferroli FZ4B Instrucciones De Uso E Instalación

CONTROLLO ZONE FZ4B

3. FIRST STARTUP (AUTOCONFIGURATION)

After carrying out the connection operations, switch on the power to the boiler; set the heating and DHW set points to the required max. value and switch on the zone
controller only afterwards.
If present, activate the request status of possible Room Chronothermostats (closed contact) connected to the zone controller.
Press the AUTOCONFIG button or Autoconfi guration (detail 5 - Fig. 34) on the controller and keep it pressed until all the bottom LEDs blink as follows:
TS1
X01 X02
1 2 3 4 5 6 7
When all the bottom LEDs and the STATUS LED blink, release the AUTOCONFIG button or Autoconfi guration (detail 5 - Fig. 34). When the Status LED stops blinking,
make sure the bottoms LEDs that are on fi xed match the required system confi guration table (fi g. 35).
If this does not occur, check the wiring again and repeat the system AutoConfi guration procedure.
If one or more Remote Timer Controls are used, at the end of the Autoconfi guration procedure the Heating and DHW setpoints must be set (see the relevant documentation).
82
04
fi g. 34 - AUTOCONFIGURATION activation
D20 D18
X03
8 9 10 11 12 13 14 15 16
fi g. 35 - Saving of system confi guration
D17
DISP1
U01
C04
U03
C01 C03
D22
D22
D22
D22
D22
D08 D09 D10
X09
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33
5
DISP1
U01
D11 D12 D13 D14
X10 X11 X12
EN
D17
D15 D16
X13 X14