Operation; Vacuum Cleaning - Dirt Devil Galileo M8000 Manual De Instrucciones

3 Operation

3.1 Vacuum cleaning

3 Operation
14
1
2
15
1
16
17
WARNING:
Danger of injury! A damaged appliance must never be
used. Check the vacuum cleaner and the power cord
each time before using it.
ATTENTION:
Only use the cylinder vacuum cleaner when all filters are
intact, dry and correctly fitted. Make sure that no open-
ings are clogged. Otherwise the vacuum cleaner might
be damaged.
1. Attach the desired nozzle,
2
Chapter 2.4, 'Fitting on the selected nozzle'.
2. Pull out the power cord until the yellow marking is visible
(Fig. 14/1).
WARNING:
Danger of electric shock! If the red marking shows
(Fig. 14/2) retract the cord by pressing the retract button
to pull in the cable (Fig. 15/1) up to the yellow mark
again. Otherwise the cable can tear off.
3. Insert the mains plug into a socket with ground/safety
contact.
4. Switch on the cylinder vacuum cleaner with the on/off
switch (Fig. 15/2). The LED display (Fig. 1/5) is illumi-
nated blue.
5. Set the selector to "carpet" or "hard floor" according to
the floor covering to be cleaned:
- Carpet (Fig. 16):
For deep- and short-pile carpets, runners, etc.
- Hard floor (Fig. 17):
For laminate, tiles, PVC, etc.
6. When working with the vacuum cleaner, pull it after you
like a sleigh. Follow the recommendations of the floor-
ing manufacturers.
WARNING:
Danger of injury! Especially when vacuum-cleaning stairs
make sure that you always stand on a higher level than
the appliance.
Chapter 2.2, 'Assembly' or
37