Embedded Water Softener; Filling The Detergent - Mocom Millwashing Manual Del Operador

EMBEDDED
WATER SOFTENER
FILLING THE
DETERGENT
10
Mount the supplied ring nut and the pipe-union on the threaded connector and seal with
the washer.
Use the supplied draining pipe to connect both pipe-unions (side equipment and central
drain); tight with clamps.
Pipe-union and ring nut
Central drain
connector
The embedded water softener is made up of resin filters that reduce the salinity of the
water supplying the machine.
In case of particularly hard water, the unit deteriorates quickly affecting its performance
and life.
In order to keep active, it is necessary to periodically regenerated the resins, especially
when the display shows the message "SALT LOAD" or "CLN" (see Appendix C
"Maintenance")
In the units equipped with this device, the installer should program, according to the
water hardness, a special parameter for showing the regeneration message as
necessary.
The compartment under the door includes one 500 cc dispenser for the liquid detergent
and a pump to dose the detergent ; the dose value is programmable and preset
according to the data of the detergent manufacturer (average consumption about 18 cc.
per cycle).
TO ENSURE THE CORRECT OPERATION OF THE PUMPS, HAVE
THE GENERAL MAINTENANCE CARRIED OUT AS PER THE
SCHEDULE INCLUDED IN APPENDIX C.
Open the door of the lower compartment and fill the container with the detergent.
I
T IS RECOMMENDED TO USE THE DETERGENT
DR.WEIGHERT
S A
EE PPENDIX
F
OR MORE DETAILS CALL THE CUSTOMER SUPPORT OR THE RESELLER
The units signals the lack of detergent by a message on the display. For further details
see Appendix "E".
T
HE UNIT CARRIES OUT THE CYCLE ALSO WITHOUT DETERGENT
Water
outlet
Washer
(supplied)
Clamp
Drain pipe
(supplied)
Clamp
WARNING
NOTE
.
COMPANY
A" – T
ECHNICAL CHARACTERISTICS
NOTE
Power
cord
"MEDICLEAN"
BY THE
.
.
.