battery to explode or flammable liquids or
gases to leak from the battery.
2.2
If a battery has been damaged
–
Do not use the machine if the battery is
damaged or has been modified. Stop using
the machine immediately if you notice
anything unusual about the battery such
as odour formation or the generation of
heat. Batteries which are damaged or
which have been modified may exhibit
unpredictable behaviour which could lead
to heat and smoke, fire, explosion or injury.
Never use water to extinguish burning Li-
–
ion batteries! Use sand or a fire blanket.
There is a risk of vapours being released if
–
the battery is damaged or not used
correctly. The vapours may irritate your
airways. Seek fresh air and consult a
doctor if you feel unwell.
Fluid may leak out of the battery if it is
–
used incorrectly. Avoid contact with the
fluid. Rinse with water any areas which
accidentally come into contact with the
fluid. If fluid gets into the eyes, also
consult a doctor. Leaking battery fluid can
cause skin irritation or burns.
2.3
Safe handling of the machine
Do not use the machine in the rain or in
–
damp surroundings. Moisture in the
machine may cause a short circuit and fire.
–
Do not use the machine as a work bench or
work surface. Do not stand or sit on the
machine. This could damage the battery
and result in a fire or explosion.
Do not transport sharp, hot or damp
–
objects (liquids, pastes, or similar) in the
machine. Only transport objects with a
maximum weight of 5 kg and do not over
fill the machine. You must be able to close
the lid without using force. This could
otherwise damage the battery and result in
a fire or explosion.
Risk of explosion due to improper battery
–
replacement or use of an incorrect battery
type. Only Festool customer service agents
may replace the integrated battery.
Do not dispose of the device or battery in a
–
fire or hot oven, and do not crush or cut
them mechanically; this may cause an
explosion. For correct disposal, see
chapter
8
.
CAUTION! The mains plug is used to
–
disconnect the machine from the power
supply. The socket should be located near
the machine and must be easily accessible
at all times.
–
Do not set the machine to a high
volume for long periods of time to prevent
potential hearing damage.
Hands and fingers must not be
–
located between the lid and the bottom
section when the machine is open. If the lid
falls shut, this may result in injuries to
hands and fingers.
2.4
Information on charging the machine
Only charge the machine with the original
–
mains adapter supplied. There is a risk of
fire when using an unsuitable mains
adapter.
–
Only charge the machine at a room
temperature between 0 °C and 45 °C (32 °F
and 113 °F).
3
Operation
Detailed information on operation: See the
sticker in the lid. Detailed operating instruc
tions are available for download on the machine
page at www.festool.com.
4
Intended use
–
Transporting and storing tools and acces
sories.
Receiving and reproducing Bluetooth
–
signals.
–
Charging smart devices via USB 2.0.
–
Use in a system with other Systainers.
–
Connection with another TOPROCK BT 20
(stereo function).
–
Use in a vehicle system.
English
®
9