Maintenance; Removing The Embroidery Foot; Attaching The Embroidery Foot; Cleaning - Singer EM200 Manual De Instrucciones

M
AINTENANCE
CAUTION
To reduce the risk of electric shock, disconnect the
power line plug from the electric outlet before carrying
out any maintenance.

REMOVING THE EMBROIDERY FOOT

When cleaning the machine, you should remove the
embroidery foot.
1. Turn the hand wheel toward you until the needle is at its
highest position.
2. Raise the presser foot lifter.
3. Remove the presser foot screw and remove the embroidery
presser foot.
A E
TTACHING THE MBROIDERY
1. Turn the hand wheel toward you until the needle is at its
highest position.
2. Raise the presser foot lifter.
3. Attach the embroidery foot to the presser bar (a) so that the
arm (b) of foot rest securely on the shaft (c) of the needle
clamp.
Attach the presser foot screw and tighten it.
(It may be helpful to lower the needle slightly when
attaching the presser foot and presser foot screw.)
a

CLEANING

If lint and bits of thread accumulate in the hook, this will
interfere with the smooth operation of the machine. Check
regularly and clean the stitching mechanism as needed.
NOTE:
* An LED lamp is used to illuminate the stitching area. It does
not require replacement. In the unlikely event it does not
light up, call your authorized SINGER® retailer for service.
* There is no need to lubricate this machine.
F
OOT
b
c
B H
OBBIN OLDER
Remove the bobbin cover and bobbin.
Clean the bobbin holder with a brush.
H R F
OOK ACE AND EED
1. Remove the needle, presser foot and holder. Remove the
bobbin cover and bobbin. Remove the screws holding the
needle plate.
2. Remove the needle plate by lifting up the right side of the
plate.
1
3. Lift up the bobbin holder and remove it.
CAUTION
To prevent accidents, do not touch the thread cutter
unit (a).
4. Clean the hook race, feed dogs and bobbin holder with a
brush. Also clean them, using a soft, dry cloth.
a
3
5. Replace the bobbin holder into the hook race so that the tip
(b) fi ts to the stopper (c) as shown.
6. Replace the needle plate inserting the hook into the
machine.
Replace the screws and tighten.
5
b
c
27
D
OG
2
4
6