Installing Your Appliance; Installation - Ducting Version - Beko CHS 30100 SS Manual De Usuario

4

Installing your appliance

4.1 Installation - Ducting
version
After having choosen the vent
option, proceed as follows:
Step 2
Remove the round transition from its seat by
unscrewing the its fixing screws (save the screws).
Step 3
Remove the grease filters.
Step 4
Remove the junction box cover.
Remove either the top or the back wiring knockout
according the preference and install an approved
wiring clamp
12 / 56 EN
Step 5
Remove the duct knockouts using a flat blade
screwdriver and a small hammer.
Use the screwdriver by knocking out the pannel in
similar fashion to a scalpel.
Take care of sharp edges.
If it is intended to use the hood in
C
the recirculating version do not
remove any duct knockouts and
order the necessary charcoal filter
from your supplier.
R1 = Remove rectangular duct knockout only.
R2 = Remove semicircular and rectangular duct
knockouts
Range Hood / User Manual