Switching On The Machine - ASBER EASY-500 Serie Manual De Instrucciones

asberprofessional.com
90 S CYCLE
6.1.2

Switching on the machine

Before switching on the machine, check the following:
To switch on the machine, just move the selector switch from 0 to any of the wash cycles. (See fig-
ure).
6.1.2.1 Filling and heating.
When the machine is switched on, it will start to fill. First the rinse boiler is filled and then the wash
tub. The filling process may last a few minutes. Once the wash tub is full, the boiler starts to heat up
and when it is hot, the tub is heated. Although it is possible to start the wash process, this is not rec-
ommended as the water inside the machine is not yet at the ideal temperature. When the machine
has reached the ideal temperature for washing the dishes properly, the green light comes on, advising
the user that the machine is ready.
The required temperature of the machine is 85 C / 185 F in the rinse boiler and 60 C / 140 F in the
wash tub. ASBER recommends that the water in the dishwasher is changed every 40/50 washes or
twice a day.
46 asberprofessional.com
180 S CYCLE
Figure 9. EASY 500 HP control button
The mains switch must be on.
The water stop cock must be open.
There must be water in the mains network.
The corresponding filters must be in place.
The overflow should be mounted in place.
The door must be closed for the machine to start filling. For safety
reasons, if the door is open, the machine will not fill.
MACHINE OFF
DRAINAGE CYCLE
(Only for EASY 500 HP B, W B models)
ENGLISH