Before Using - Metabo HPT C 3607DRA Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
(4) When charging is completed
○ The USB power indicator lamp will not go out when a
USB device has been completely charged.
To verify charge status, check the USB device.
○ Turn the USB power switch OFF and unplug the power
cord from the electrical outlet. (Fig. 14)
○ Remove the battery from the charger and place the
rubber cover over the USB port.

BEFORE USING

Power tool
WARNING
Check steps 1 through 6 before you have
installed the power supply (battery) to the tool.
1. Make sure the trigger switch is turned OFF.
WARNING
If the battery is inserted while the power switch
is in the ON position, the power tool will start
operating immediately, inviting serious accident.
2. Check the saw blade for visible defects.
Confi rm that the saw blade is free of cracks or other
visible damage.
3. Confi rm that the saw blade is attached securely to the
power tool.
Using the supplied 5 mm hex. bar wrench, tighten the
left hex. 7 mm socket bolt on the saw blade spindle to
secure the saw blade.
For details, see Fig. 51-a and Fig. 51-b in the section
on "SAW BLADE MOUNTING AND DISMOUNTING".
4. Check the lower guard for proper operation.
Lower guard is designed to protect the operator
from coming into contact with the saw blade during
operation of the tool.
Always check that the lower guard moves smoothly
and covers the saw blade properly.
20
Saw blade
Lower guard
Fig. 15
WARNING
NEVER OPERATE THE POWER TOOL if the lower
guard does not function smoothly.
5. Confi rm the position of the spindle lock before using
the tool.
After installing the saw blade, confi rm that the spindle
lock has been returned to the released position before
using the power tool (see Fig. 3).
6. Eye protection
Always wear eye protection with side shields that
meets the requirements of ANSI Standard Z87.1.
Ordinary eyeglasses do not provide adequate
protection because they do not contain impact
resistant safety glass.
WARNING
Operating the tool without wearing proper eye
protection may result in serious injury.
AFTER INSTALLING THE POWER SUPPLY (BATTERY)
TO THE TOOL, CHECK THE OPERATION OF THE
TOOL AS FOLLOWS:
7. Electric brake
This tool is equipped with an electric brake which will
typically stop the blade within 5 seconds after the
trigger switch is released.
Occasionally, there will be a delay in the brake
engaging which will result in a longer blade stopping
time. On rare occasions, the brake may not engage at
all and the saw blade will coast to a stop.
If the brake fails to engage frequently, depress and
release the trigger switch to turn the tool on and off
4 or 5 times. If the brake still does not engage, have
the tool serviced at a metabo HPT authorized service
center.
Always confi rm that the saw blade has completely
stopped before raising it from the workpiece.
The brake is not a substitute for a properly functioning
lower guard. Check the function of the lower guard
before each use. Serious personal injury may occur
if the lower guard does not move smoothly and cover
the blade properly.
WARNING
Please be aware of the reaction of the Motor
Head (Fig.2) when the brake is activated. Braking
causes the Motor Head to jerk downward and
the user should be prepared for this reaction,
especially when the trigger switch is released
before the blade is completely down. Failure to

Publicidad

Tabla de contenido
loading

Tabla de contenido