Troubleshooting
Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Problem
No power
Cabinet temperature
is too high.
Condensation on
the cabinet, doors or
fl oor.
Beverage centre runs
continuously.
Danby Consumer Care: 1-800-263-2629
Possible Cause
•
A fuse in your home may be
blown or the circuit breaker
tripped.
•
Power surge.
•
Plug not fully inserted into
the wall outlet.
•
Temperature setting.
•
Door not shut properly or
opened excessively.
•
Recently added a large
quantity of warm bottles to
the cabinet.
•
High humidity conditions in
the home.
•
Door not shut properly or
opened excessively.
•
Temperature set too cold.
•
Door is not closed.
•
Door opened too long or too
often.
•
Close proximity to heat
source or direct sunlight.
What to do
•
Replace fuse or reset circuit breaker.
•
Unplug the appliance, wait a few
seconds and then plug it back in
•
Make sure the 3-prong plug is fully
inserted into the outlet.
•
Verify the temperature control setting.
Adjust if neccessary.
•
Ensure that the door is fully closed
and that the gasket is sealing against
the cabinets. Open the door only as
needed and for short periods of time.
•
Limit the quantity of warm bottles
being introduced to the cabinet at the
same time. Attempt to stagger the
load introduction if possible.
•
The condensation will subside once
humidity conditions return to normal.
•
Ensure that the door is fully closed
and that the gasket is sealing. against
the cabinets. Open the door only as
needed and for short periods of time
•
Adjust temperature to warmer setting.
•
Close door securely.
•
Minimize door opening duration and
frequency.
•
Do not place unit close to heat
sources or direct sunlight.
9