Technical Data; Noise And Vibration Information - MIRKA LEROS Instrucciones De Manejo

en

Technical data

Mirka® LEROS
Power
Mains voltage
Speed
Orbit
Size of backing pad
Weight
Degree of protection

Noise and vibration information

Measured values are determined according to EN 62841-1
Mirka® LEROS
Sound pressure level (L
Sound power level (L
Sound measurement uncertainty K
Vibration emission value a
Vibration emission uncertainty K *
Specifications subject to change without prior notice Model range may vary between markets
* The values stated in the table are derived from laboratory testing in conformity with stated codes and standards and
are not sufficient for risk evaluation Values measured in a particular work place may be higher than the declared
values The actual exposure values and amount of risk or harm experienced by an individual are unique to each
situation and depend upon the surrounding environment, the way in which the individual works, the particular
material being worked, work station design and the user's exposure time and physical condition Mirka Ltd accepts
no responsibility for the consequences of using declared values instead of actual exposure values for any individual
risk assessment
Further occupational health and safety information can be obtained from the following websites:
https://osha europa eu/en (Europe) or http://www osha gov (USA)
Proper use of tool
This sander is designed for sanding plaster, paint, wood, plastics, etc using abrasives designed for this purpose Do not
use this sander for any other purpose than that specified without consulting the manufacturer or the manufacturer's
authorized supplier Do not use backing pads that have a working speed less than 8,000 rpm free speed The cooling
air vents on the tool must be kept clean and free of blockages to ensure air circulation Any maintenance or repair work
requiring the tool to be opened may only be carried out by an authorized service center
Work stations
The tool is intended to be operated as a hand-held tool It is always recommended that the tool should be used when
standing on a solid floor It can be used in any position but before any such use, the operator must be in a secure
position have a firm grip and footing, and be aware that the sander can develop a torque reaction See the section
"Operating Instructions"
44
Mirka® LEROS Random Orbital Sander • 225 mm (9")
950CV
350 W
220–240 VAC
4 000–8 000 rpm
5,0 mm (3/16")
Ø 225 mm (9")
3,5 kg (7,72 lbs)
I
950CV
) 84,3 dB(A)
pA
) 95,3 dB(A)
WA
3,0 dB
*
< 2,5 m/s
h
1,5 m/s
2
2