Positioning Of The Sensor In Motors Of Line Odp Ip23 - WEG Motor Scan Manual General De Instalación Y Operación

www.weg.net

7.5.3.Positioning of the sensor in motors of line ODP IP23

Due to construction features of those motors, the position chosen for the WEG Motor Scan must be
the upper rear area of the motor (Figure 7.7). The drilling and mounting position of the WEG Motor Scan
for ODP IP23 motors must follow the recommendations shown in Figure 7.8. Where D and L are the
maximum acceptable deviations.
D (maximum): 20 mm
L (maximum): 80 mm
ATTENTION!
In order to install the WEG Motor Scan on motors not covered in this manual and motors from other
manufacturers, refer to WEG: www.weg.net/wegmotorscan.
58 Manual of Electric Motors
Figure 7.7 –WEG Motor Scan mounting location for the ODP IP23 line
L
Figure 7.8 – Detail of the drilling for mounting the WEG Motor Scan