Intended Use; Instructions Before Installation; Installing The Inner Frame - Dometic Heki 2 de Luxe Instrucciones De Montaje

Heki Accessory
4

Intended use

The Heki2 de Luxe inner frame (item no. 9104100241) is used to retrofit an existing
Heki2 roof light in a camper or caravan with blackout, insect screen and lighting. The
four lights cannot be dimmed.
5

Instructions before installation

➤ Make sure that the power supply line and a switch are available for the
Heki2 de Luxe inner frame lighting (12 V, 4 x 5 W) in the vehicle.
➤ Make sure that the power supply line is suitably arranged and protected.
If you do not want lighting, the bulb holder must be removed before installation, and
after mounting the ventilation grille must be inserted instead of the lamp cover.
6

Installing the inner frame

I
NOTE
Get another person to assist you in removing the old inner frame and
installing the new inner frame.
➤ If you do not want to use the lighting: Remove the bulb holder in the new inner
frame.
➤ Remove the inner frame of the existing Heki2 roof light (fig. 2 – fig. 4).
➤ Lay the power supply line in the middle onto one of the two long sides.
➤ Allow the power supply line to protrude about 25 cm between the roof opening
and the outer frame (fig. 5).
A
NOTICE!
Connect the lighting on only one side.
I
NOTE
The connection is designed for an insulated flat plug which is 4.8 mm
wide and 0.8 mm thick.
EN
Intended use
5