Door Reversibility - Zanussi ZRB835NW1 Manual De Instrucciones

B
A
Rear spacers
You can find the two spacers in the bag with documenta-
tion.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
4
Levelling
When placing the appli-
ance ensure that it stands
level. This can be achieved
by two adjustable feet at
the bottom in front.
14
2
1
3
Removing the shelf holders
Your appliance is equipped with shelf retainers that make
it possible to secure the shelves during transportation.
To remove them proceed
as follows:
1. Move the shelf hold-
ers in the direction of
the arrow (A).
2. Raise the shelf from
the rear and push it
forward until it is
freed (B).
3. Remove the retainers
(C).
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the do-
mestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.

Door reversibility

Warning! Before carrying out any operations,
remove the plug from the power socket.
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.