Sunrise Medical QUICKIE Easy 200 Manual De Usuario página 17

Lower leg lengths
By undoing the clamp screw
(Fig. 5.18), you can adjust the
lower leg length. Loosen the
clamp screw, adjust the tube
with the footboard to the desired
position.
Tighten clamp screws again (see
the page on torque). Ensure that
the plastic push joint is located
under the clamp screw in the
correct position.
WARNING!
Do not stand on the footboard!
When transferring, do not stand on the footboard, there is a risk
of tipping over and injury.
High-Mount Footrest
(Fig. 5.19 - 5.19.1)
The footplates can be flipped up to
facilitate getting in and out of your
wheelchair.
The footplates can be adjusted within
their angle of inclination, relative to a
level surface. Loosen the screws (1
to 2). Then set the footplates to the
desired angle. Afterwards, tighten
all screws. After adjustment, always
make sure that all screws are tightened
properly (see the page on Torque). In
order to avoid the wheelchair tipping
over, make sure that the minimum
interval of 2.5 cm between the foot rest
tubing and the ground is maintained
(with horizontal seat).
Automatic folding footrest
The footrest angle can be adjusted by loosening the screws
(1) and turning the footrest. When tightening, please note the
torque measurements, (Fig.5.19.2).
Fig. 5.19.2
Fig. 5.18
Fig. 5.19
1
2
Fig. 5.19.1
3 4
Option Elevating legrest
(Fig.5.19.3 - 5.19.5)
To remove, pull the lever (1), swing the footplate outwards and
then lift the legrest out.
Height Adjustment:
The lower leg length can be adjusted infinitely by releasing the
screw (2). Adjust the suitable height and tighten the screw
again.
CAUTION!
The distance between the footplate and the ground must be at
least 40 mm.
Angle Adjustment:
Press the lever (3) downward with one hand while supporting
the legrest with the other hand to take the load off. When a
suitable angle is achieved, let go of the lever and the legrest will
lock into one of the preset positions.
WARNING!
• Keep hands clear of the adjustment mechanism between the
frame and the movable parts of the footrest while elevating or
lowering the footrest.
• The footrests should not be used to lift or to carry the
wheelchair.
• Risk of trapping fingers!
• When moving the footrest up or down, do not put your fingers
in the adjusting mechanism between the moving parts of the
footrest.
Fig. 5.19.3
1
3
Fig. 5.19.4
2
Fig. 5.19.5
EASY 200-300
17