Using The Ice Maker (Only Cfx3 55Im) - Dometic CFX3 35 Instrucciones De Uso

CFX3
➤ Proceed as shown (fig. i, page 14).
7.13

Using the ice maker (only CFX3 55IM)

I
NOTE
• Independent of the main compartment's temperature setting, the
ice maker zone is designed for making ice cubes if the ice maker is
switched on.
• The cooler's energy consumption increases with ice maker on.
Therefore you should switch off the ice maker if it is not needed.
• The factory setting for the ice maker is OFF.
➤ Proceed as shown (fig. j, page 14).
Filling the ice trays with water
➤ Remove the ice trays (fig. k 1, page 15) from the ice maker housing (fig. k 2,
page 15).
➤ Remove the ice tray covers, fill with clean water and re-fit the cover, taking care to
press the edge seal all the way around.
➤ Re-position the ice trays in the ice maker housing and close the lid.
I
NOTE
Dry any water spillage from under the ice trays.
This will reduce ice build up under the trays and make removal easier.
Removing the ice cubes
➤ Open the ice maker housing lid and lift under the front of the ice trays.
I
NOTE
Removal may require additional force using two hands in high humidity
conditions which may create an ice bond underneath the ice trays.
➤ Remove the ice tray covers and twist trays to release the ice cubes.
Removing the ice maker housing
The ice maker housing can be removed for cleaning or when not in use to increase
usable space inside the cooler:
➤ Lift the housing at one end until the lug unclips, then remove.
➤ Reverse procedure for re-fit, pushing down on lugs to snap into position.
EN
Operation
29