How To Use Auto Menus - Panasonic MX-ZX1800 Instrucciones De Funcionamiento

How to Use Auto Menus

Preparation
① Attach the blender jug and blender jug base. (P. GB14-15)
② Prepare ingredients and put them in the blender jug. (P. GB17)
(Put liquid first)
1
Set the blender jug onto the motor housing.
Then plug in and turn the switch on.
The power
switch is
located on
the back.
2
Select menu and press "
・Press on the illustration to choose a menu selection.
(Figure 1: Control panel when
choosing menu selection)
Flashing
①
(e.g.: Juice is selected.)
②
GB18
Make sure the blender jug base and lid unit are attached
●
firmly. (P. GB14-15)
When using the "frozen" menu selection, insert the tamper
from the lid opening instead of attaching the cap.
Make sure the blender jug is set onto the motor housing
●
correctly, otherwise keys cannot be activated.
When you wish to use the ice pack, refer to page GB15
●
for assembly.
" to start.
When there is no action for 10 seconds after menu
●
selection is chosen, indicators will return to previous menu
selection. (Figure 1)
The blending time is shown by bars and will decrease
●
until the blending process is complete.
If you wish to adjust the blending time, turn the dial to
●
the left or right to respectively make the time shorter or
longer before pressing " " key. (P. GB16)
Auto menus will stop automatically but if you need to
●
stop during a process, press " ".
When you need to use the tamper during blending,
●
follow the instructions on page GB19.
3
After you hear beep sounds for completion, wait until the
blade stops completely and remove the blender jug. Check
texture and consistency of the mixture.
When you need additional blending, re-set the blender jug and use manual mode on page GB21 for
additional blending.
Beware of splashing liquid when you open the lid unit vigorously.
●
Pour out mixture from the blender jug or take out from the blender jug by
●
using a rubber scraper or spatula. Do not put your hands in the blender
jug.
After using, turn off the power switch on the back and unplug.
●
* If the blender stops halfway while blending, circuit breaker protection is
activated. Follow the instructions on page GB23 and GB24 to release it.
<To use the tamper during blending>
■ Use the tamper when ingredients are not circulating or if you need to mash the ingredients during blending. (e.g.
blending large quantity of leafy vegetables, blending ingredients low liquid contents, or using "Frozen" menu selection.)
(e.g.: When using the "Frozen" menu selection.)
① Press " ".
Flashing
② Open the cap by turning anticlockwise after blade is completely stopped.
・Make sure the lid is pushed in firmly.
③ Insert the tamper through the lid opening and press "
・Do not insert any other utensils. Only use the tamper provided.
④ Move the tamper to circulate or mash ingredients evenly.
・ Pushing the tamper straight down may not circulate ingredients. If
necessary, move the tamper toward the sides of the blender jug.
・Hold the lid while using the tamper.
Note
● Insert tamper or add ingredients within 10 seconds after "
is pressed. Otherwise, menu selection will be canceled.
● When the tamper is used to press and hold down sticky ingredients,
like bananas, the circuit breaker may be triggered (P . GB25).
Flashing
".
"
GB19