Kenwood KPA-SD100 Manual De Instrucciones página 6

Connection of centre unit to vehicle
Connecting the KPA-SD100 only
Connection cable4
KPA-SD100
IF/IN
Connection cable
(ISO C )3
Connections for remote control light emitter, etc.
1. Remove the connector cover.
2. Connect each connector.
3. When you have finished connecting
the required connectors, put the
cover back in place.
Installing the remote control light emitter
The purpose of the remote control light emitter is to transmit the signal from the steering remote
control to the centre unit. Please install it in a position where the centre unit can detect the
signal.
2CAUTION
Please install the remote control light emitter in such a way that the cable does not rub against the fitting, as this could
damage the cable.
6-
English
Downloaded from:
TO CH TO H/U
A B
DISPLAY OUT
IF/OUT
Centre Unit
KPA-CP100
(Option)
Connection cable
(ISO AB )2
To vehicle
http://www.usersmanualguide.com/
Connecting the KPA-SD100 and the KPA-SS100
Connection cable(Provided with the KPA-SS100)
Connection
cable4
KPA-SD100
TO CH
IF/IN
Centre Unit
Connection cable
(ISO C )3
To vehicle
Steering wheel
KPA-CP100
remote control
(Option)
light emitter1
SCAN
LOUD
Steering wheel
remote control
light emitter1
KPA-SS100
(Option)
TO H/U
A B
DISPLAY OUT
IF/OUT IF/IN
Connection cable
(ISO AB )2
PWR
OFF
DISC
DAB
EJECT
RDM REP D.SCN M.RDM MENU
AUTO DISP
AME NAME.S
NF
AUD
DISC
IF/OUT
KPA-CP100
(Option)