Fermax CITYLINE VDS SMILE Serie Manual De Instalador Y Usuario página 67

SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS SMILE VDS
4. The selected option is displayed with the white line under the icon. Press, and a
screen appears confirming the selected option: programming from the panel and you
hear a beep on the monitor.
_ _ _
_ _ _
2222
4444
5. The monitor automatically connects to the street panel, activating the camera (this
shows a panel icon in the upper left corner of the monitor). Enter the calling code for this
monitor from the panel. Depending on the type of panel installed:
- pressing the corresponding button or
- by entering the code + bell.
Notes:
- The time between steps 4 and 5 must be less than 2 and half minutes.
- Programming is always done from the panel activated as the main panel.
Panel
1
icon
A different calling tone is produced, confirming the monitor´s programming, continuing to view
the camera's image and after a few seconds the monitor returns to the programming
Note:
- The wildcard button
exiting programming, this button stops blinking, indicating that the monitor is programmed.
- If you want to re-program the monitor the administrator code is 4444.
6. Exit Programming: When you press
Continue pressing
exit programming mode after 60 seconds of inactivity.
• • • • •
For more monitor information download the 97711 manual in: www.fermax.com
will continue blinking (red) until having exited programming. Upon


until you exit programming. The monitor will also automatically
Notes:
- The time between steps 4 and 5 must be
less than 2 and half minutes.
- Programming is always done from the pa-
nel activated as the main panel.
you exit to the previous programming menu.
screen.
Page 27