Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Install the device on a plane surface. Carrying bracket is not intended
for mounted installation.
During operation of the device, liquid may form around the machine.
The liquid tank of the device needs to be filled with bubble liquid before
starting up operation and always disconnected from the mains as fluid
could be spilled.
If fluid should get into the interior of the device, disconnect from mains
immediately and consult a technician.
OPERATION
Install the device on a plane surface.
Operation via the included power-unit
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
Inserting/Replacing the batteries
Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the batteries, remove the old batteries from the battery compartment.
Caution!
Danger of explosion when batteries are replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty batteries in accordance with the instructions of the manufacturer.
Insert the batteries and make sure that the poles are correct.
Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.
With the POWER-switch, you can switch the device on and off.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.
9/18
00026316.DOC, Version 1.1
Publicidad
Tabla de contenido
