Remote Control; Elebia® Remote Control / Working Modes; Power Settings; Display Information - Elebia e5 Manual Del Usuario

Remote control

Mode button
'0 to 9' – autohook battery level
'C' - Check / maintenance
' . ' ring in position
(only units with magnet sensor)
´A´- Remote's battery is low
elebia® button
Power supply
Available Code Combinations
Detection of Errors in Transmission
Buttons
Frequency selection
Frequencies
Communication
Certification standards
Radiated power
Antenna
Range
Consumption at rest/transmission operation
Working temperature
Dimensions
Working modes
The remote can work in 2 different modes:
> 'One button' mode:
'elebia®' button: open and closes the hook.
> 'Two buttons' mode:
'elebia®' button: closes the hook
'mode' button: opens the hook
To switch between modes, press and hold the
'elebia®' button for 10 seconds.

Power settings

The power of the motor can be adjusted in an
elebia® technical service.
Disclaimer: This brochure is for information only. The manufacturer reserves the right to modify specifications.
1 3V lithium battery (CR2032)
65,536 different combinations
2 CRC bytes + Forward Error Correction
2
1
865.95 MHz / 869.85 MHz
Bi-directional return of receiver battery status
EN 300 220 Telecommunications
EN 301 489 Electromagnetic Compatibility
EN 60730 Low Voltage
under 5 dBm
Printed circuit
100 metres / 330 Feet
5 uA/ 20 mA
-20 to +85ºC / -4 to 185 ºF
Minitel box (68 x 52 x 17 mm / 2,68 x 2,05 x 0,67 inches)

Display information

0 to 9: autohook battery level
A: remote battery is low
. (just autohooks with magnet sensor): the
ring sling or handle is in position, ready to
close the hook.
C: it's time for maintenance of your autohook.
1b: you've entered the 'one button' mode
2b: you've entered the 'two button' mode
b: the remote doesn't detect the hook
- battery is not inserted.
- battery is off
- battery is empty
9