Garland 790 G Manual De Instrucciones página 30

29 | English
CAMBIO DE CUCHILLAS
MAINTENANCE
WARNING!
PRIORS TO ANY MAINTENANCE, TO STOP
ENGINE AND SWITCH IT OFF FIRST.
DISCONNECT SPARK PLUG WIRE FROM THE
SPARK PLUG TO PREVENT UNINTENTIONAL
ENGINE STARTING.
UNINTENTIONAL SPARKING CAN RESULT IN FIRE.
UNINTENTIONAL START-UP CAN RESULT IN
ENTANGLEMENT, TRAUMATIC AMPUTATION
OR LACERATION.
USE ONLY GENUINE REPLACEMENT ENGINE PARTS.
NON COMPLIANT PARTS MAY DAMAGE
THE ENGINE, AND MAY RESULT IN INJURY.
IN ADDITION, USE OF OTHER PARTS MAY VOID
YOUR WARRANTY RIGHTS.
REPLACING BLADES
Sharpen or replace the blades as soon as the chipping
performance begins to deteriorate, or if you notice
digns, chips or cracks.
To perform this procedure:
1. Turn off the machine, allow all moving parts to
come to a complete stop, and disconnect the spark
plug wire!
2. Remove the side cover plate to expose the blades.
3. Remove one blade, rotate the impeller, and remove
the second blade.
4. Have the original blades professionally sharpened,
or order a replacement set, then re-install the
blades.
5. Replace the side cover plate and re-attach the
spark plug wire.
Side cover
REPLACING V-BELT
Replace or tighten the V-belt you notice the motor
running and the chipper blades are not spinning.
1. Turn off the machine, allow all moving parts to
come to a complete stop, and disconnect the spark
plug wire!
2. Remove the V-belt cover as shown in.
3. Roll the belt off of the pulleys and install the new
belt.
4. Replace the V-belt cover and re-attach the spark
plug wire.
V-belt cover
Blade