Connection With The Mains; Operation; Addressing - EuroLite RGB TL-150 DMX Manual Del Usuario

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the RGB TL-150 DMX starts running.
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.

Addressing

Each color changer occupies 3 channels. To ensure that the control signals are properly directed to each
color changer, the projector requires adressing. This is to be done for every single color changer by
changing the DIP switches as set out in this table.
The starting address is defined as the first channel from which the RGB TL-150 DMX will respond to the
controller. If you set, for example, the address to channel 4, the RGB TL-150 DMX will use the channel 4 to 6
for control.
Please make sure that you don't have any overlapping channels in order to control each RGB TL-150 DMX
correctly and independently from any other fixture on the DMX data link. If two, three or more RGB TL-150
DMX are addressed similarly, they will work similarly.
Occupation of the DIP-switches:
International
L
N
22/47 00025997.DOC, Version 1.2