Stihl FSE 31 Manual De Instrucciones página 26

English
To reduce the risk of accidents and
personal injury, do not operate the unit if
it is not properly assembled and in good
condition.
Do not operate your power tool if any of
its components are damaged or not
properly mounted.
Never attempt to modify the controls or
the safety devices in any way.
Before switching on your power tool,
make sure the cutting attachment is not
touching the ground or any other object.
To reduce the risk of
injury, avoid contact with
the cutting attachment.
Note that the cutting
attachment continues to
run for a short period
after the power tool is
switched off – flywheel
effect.
Electrical Connection.
Reduce the risk of electric shock:
Voltage and frequency of the
–
machine (see rating plate) and the
voltage and frequency of your
power supply must be the same.
Check the connecting cord, plug
–
and extension cord for damage.
Never use damaged cords,
couplings and plugs or connecting
cords that do not comply with
regulations.
Always connect the power tool to a
–
properly installed wall outlet.
24
Check that the insulation of the
–
power cord, extension cord, plug
and coupling is in good condition.
Never touch the mains plug, power
–
cord, extension cord or electrical
connections with wet hands.
Make sure the extension cord used
–
complies with the regulations for the
intended application.
Position the connecting and extension
cords correctly:
Check minimum cross section of
–
wires (wire gauge) – see
"Connecting to Power Supply".
To reduce the risk of stumbling,
–
position and mark the connecting
cord so that it cannot be damaged
or endanger others.
Using unsuitable extension cords
–
can be dangerous. Use only
extension cords approved for
outdoor use which are labeled as
such and have the appropriate wire
gauge.
The plug and coupling of the
–
extension cord must be water-proof
and must never be immersed in
water.
Do not chafe on edges, pointed or
–
sharp objects
Do not squeeze through gaps in
–
doors or windows
If cords are twisted – unplug the
–
power tool and straighten them out
Never touch the rotating cutting
–
attachment
Always unwind the extension cord
–
completely from the cable drum to
reduce the risk of fire from
overheating.
Holding and Controlling the Power Tool
Always hold the unit firmly with both
hands on the handles. Make sure you
always have good balance and secure
footing.
Always hold the machine on the right-
hand side of your body.
Left hand on the assist handle, right
hand on the control handle, even if you
are left-handed.
During Operation
If the power supply cord
is damaged, immediately
disconnect the plug from
the wall outlet to avoid
the risk of electric shock.
Avoid damage to the power supply cord.
Do not drive over it, pinch or tug it.
Never jerk the power cord to disconnect
it from the wall outlet. To unplug, grasp
the plug, not the cord.
FSE 31, FSE 41