Gloria ThermoFLAMM bio Instrucciones De Uso página 11

Before assembly, check that the O-ring is
G
in the screw threads of the valve,
see Fig. .
1
Close the valve. Turn the black valve
G
knob fully to the right (clockwise), see
2
Fig. . Only do it up finger-tight and
without force.
Turn the gas cartridge to the right (in a
G
clockwise direction as viewed from the
cartridge base), screw in and ensure that
the gas cartridge is fastened correctly,
see Fig. 3 . Only finger tighten the gas
cartridge.
Open the valve.Turn the black control
G
knob to the left until it comes up against
the stop, see Fig.
ATTENTION! If the valve is not com-
pletely open, the flame could backfire.
In a safe area, aim the shaft of the unit
G
down wards and away from your body.
.
4
Press the but ton of the piezoelectric ignit-
5
er, see Fig. . Hold the shaft at a height
of about 3 cm above the ground and move
it slowly from side to side.
holes are closed, the flame goes back up
to the hand tube, which can overheat
excessively and damage the unit.
Ensure when starting up that the unit is
G
held in front of the body and the gas
cartridge is held vertically downwards.
G
6
. If the