Service And Maintenance; Accessories; Environment - Festool MFK 700 EQ Manual De Instrucciones Original

► Tighten the screws [9-2].
Rough adjustment
► Loosen the screws [9-2] and [9-4] and slide
the side stop.
► Tighten the screws.
Edge trimming with bearing guide [Fig. 10]
Use routing tools with a bearing guide in the
machine when edge trimming with the large
surface router table. The machine is then gui­
ded in such a way that the bearing guide rolls
off the workpiece. When trimming edges, al­
ways use the extraction hood [10-1] for im­
proved dust extraction.
Edge trimming with sensor and router table
for edge veneer [Fig. 11]
When edge trimming with the router table for
edge veneer (only in SET scope of delivery), fit
the sensor [11-1] to the machine (see Chapter
7.2 ). The machine is then guided in such a way
that the sensor rests against the workpiece.
9

Service and maintenance

WARNING
Risk of injury, electric shock
► Always pull the mains plug from the socket
before performing any servicing and main­
tenance work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
The tool is equipped with special self-discon­
necting carbon brushes. If they wear out, the
power supply is disconnected automatically and
the tool stops.
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.

10 Accessories

The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet at "www.festool.com".

11 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re­
cycling.
Information on REACH: www.festool.com/reach
English
17