OHAUS Scout Serie Manual De Instrucciones página 4

EN-2
For SPX, SKX and SJX Balances:
Upon installation, the balance will show [
PRINT
Reset: no, yes
Stable: off, on
A.Print: off
On.Stable
interval
accept
continuous
Content: Result (-> off, on)
Gross (-> off, on)
Net (-> off, on)
Tare (-> off, on)
Header (-> off, on)
Footer (-> off, on)
Mode (-> off, on)
Unit (-> off, on)
Info (-> off, on)
Layout: Format (->Single,Multi)
Feed (->Line, 4 Lines, Form)
End Print: Exit menu
Note: Items with bold font are default settings.
SETUP DEFINITIONS
Menu Settings
PRINT / A. Print – Off
PRINT / A.Print / On.Stable – Load,
Load.Zero
PRINT / A.Print / interval - (xx) sec
PRINT / Auto Print – accept
PRINT / A.Print – Continuous
PRINT / Content
PRINT / Layout / Format - (Single,
Multi)
PRINT / Layout / Feed - (Line, 4 Lines,
Form)
USB.Dev
] during the power sequence.
USB.Dev
Reset:
Baud Rate:
Parity:
Stop bit:
Handshake:
Alternate command:
End USB.Dev:
Explanation
Only sends data when PRINT is pressed.
Balance only transmits stable data.
Load: Print stable value excluding zero
Load.Zero: Print stable value including zero
Balance sends data every (xx) seconds.
Balance only sends stable accept data in
Check mode.
Balance repeatedly sends data as fast as
possible.
On: print relevant content after weighing data
Gross – on: G; Net – on: N; Tare – on: T;
Info – on: balance will print application
mode setting parameters
Single: print all data in one line
Multi: print all data in multiple lines
Line: feed one line after printing
4 Lines: feed four lines after printing
Form: feed one page after printing (move to the
top of next page after printing)
USB Device Interface
no, yes
1200...9600...115200
7 even, 7 odd, 7 none,
8 none
1, 2
none, XOn-XOff
Print (A...P...Z)
Tare (A...T...Z)
Zero (A...Z)
Exit menu