Start / Stop Procedure - Altrad BELLE TDX 650 Manual Del Operador

GB
CAUTION
Before starting the engine, make sure that the Drive Lever is at Neutral, Vibration Lever is at OFF, and the Parking Lever is at ON
position.
Open the fuel tap at the engine.
Start the Engine – Electric Start
Turn the Key Switch at the Throttle Lever to Start
DO NOT
Start the Engine – Manual Start
4a. Grasp the recoil starter handle.
4b. Pull the handle out slowly until you fee lstrong resistance.
4c. Slowly return the recoil starter to the initial position.
4d. Push the decompression lever down and then release it. The decompression lever will
automatically return to the original position when the engine starts.
4e. Grasp the recoil starter handle.
4f. Pull the handle all the way out with a strong and even motion. Use two hands if necessary.
4g. Slowly return the starter handle to the initial position.
4h. If the engine does not start, repeat the procedure from step 4b.
to warm up.
7. Move the throttle lever to the high speed "H" position quickly to prevent
damage from occurring to the clutch. The "Full Throttle" position of this
machine has been preset at the factory to achieve optimum machine
performance.
DO NOT alter this setting since premature wear or tear can result, and
both engine and machine warranty will be automatically voided.
NOTE: Negligence to disengage the Parking Brake before attempting to
drive the machine forward or reverse will result in the severe
damage to the parking brake mechanism as well as the drive system.
9. Operators Control
9a. Throttle Lever
Always keep the Throttle Lever at High position during the operation.
DO NOT attempt to alter the travel speed by changing the engine
revolution.
9b. Drive Lever
Move the Drive Lever forward to drive the machine forward.
For reverse motion, move the lever backward.
9c. Vibration Lever
By shifting the Vibration Lever to ON position, the vibration mechanism
will be engaged, and produce the vibration.
10. Stopping the Engine
to LOW position.
Then, set the Key Switch to "OFF" position. The buzzer will sound
when the Key Switch is set to ON while the engine is stopped.

Start / Stop Procedure

DO NOT
position, and hold it until the engine starts.
VIBRATION
12
THROTTLE
LEVER
LEVER
DISENGAGE
KEY
SWITCH
DRIVE
LEVER
ENGAGE