sanindusa 541057111 Instrucciones De Montaje página 43

1
Step
Installing the flush valve
1 - Shut off the water supply
2 - Cut an adequate opening in the wall for the dimensions of
the box. For transformer powered version also take into consi-
deration the corrugated tube for the transformer wire (tube is
not supplied).
3 - Insert the electronic flush valve box through the opening
4 - Connect the flush valve inlet to the water supply
5 - Connect the flush valve outlet nipple to the pipe leading to
the urinal's inlet
6 - Turn on the water supply. Make sure there is no leakage
7 - Assemble the mud guard cover to protect the flush valve.
Note the MIN and MAX marks on the box
2
Step
Connecting the power source
8 - Once the electricity, plumbing and tile works are finished, cut
the mud guard cover wherever required by the installation
9 - If your model is Unit by battery, assemble the battery box
inside the box and proceed to clause 4
10 - If your model is Unit by transformer, place the transformer
near the electricity plug and insert the transformer cable wire
through the box
// INSTALLATION
1 2
4 inlet 6
outlet
7
MIN
8
9 10
MAX
OUTLET