sanindusa 541057111 Instrucciones De Montaje página 44

// INSTALLATION
11 - Assemble the plastic seat for the wall cover plate using the
four screws provided
12 - Connect the electronic unit connectors to the solenoid
valve connector and the power source connector
3
Step
Completing the installation
13 - Assemble the panel to the cover seat and lock it with the
bottom screw
14 - Remove the protecting sticker that covers the sensor
IMPORTANT: Wait a few seconds before activating the flush
valve to avoid entering into settings adjustment
15 - Move away and the flush valve will flush a few seconds
after your departure
16 - If needed adjust the flow capacity by turning the regulating
valve
If the range is unsatisfactory, refer to the section entitled
//SETTINGS ADJUSTMENT
11
12
13
15
44 45
//
14
16