Kratki ARKE Serie Manual Del Usuario página 14

This manual, including all photographs, illustrations and trademarks, is protected by copyright.
All rights reserved. Neither this manual, nor any of the material contained herein, may be re-
produced without written permission. The information in this document is subject to change
without notice. The manufacturer reserves the right to make corrections and changes in this
manual without any obligation to notify anyone about it.
Thank you for your trust and purchase of the insert. This device has been designed for your safety and
comfort. We would like to express our conviction that you will be satisfied with your choice because of
the commitment that was involved in the design and production of the gas fireplace.
Prior to installation and use, please carefully read all of the chapters in the manual. If you have any
questions or concerns, please contact our technical department. Any additional information is avail-
able online at www.kratki.com
Introduction
Kratki.pl Marek Bal is a well-known manufacturer of heating equipment in both Poland and Europe.
Our products are based on strict standards. Each fireplace insert manufactured by the factory is sub-
jected to quality control during which it undergoes rigorous safety tests. The use of the highest quality
materials in the manufacture ensures smooth and reliable operation of the device by end users. This
manual contains all of the information necessary for proper installations, operation and maintenance
of the insert.
Note
use proper wood and clean the device regularly. Below, there are some guidelines for the proper main-
tenance of the fireplace inserts manufactured by Kratki.pl:
1. The insert and the trim should be installed by qualified personnel
2. At least once a year, the chimney duct should be inspected
3. Use dry deciduous wood with the max. moisture content of 20% for firing
4. Prior to each heating season, replace the seal (in the door, under the glass).
5. Remove the ash from the ash tray regularly
6. Do not overheat the insert: the maximum loading is 1/3 of the size of the combustion chamber
7. Clean the front window using only the preparations dedictaed for this purpose. Do not use abrasive
preparations as this can result in scratching the glass.
8. Please note that when cleaning the glass, all steel / cast iron components exposed to chemicals
should be protected. Any contact with such substances can cause corrosion, splinters or other dam-
age.
INTRODUCTION
The requirements regarding the terms and conditions for the installation of fireplace inserts can be
found in national standards and in national and local regulations.
To avoid the risk of fire, the device must be installed in accordance with the current standards and the
technical regulations referred to in the manual. Its installation must be performed by a professional.
Always observe the regulations in force where the unit is installed.
First, make sure that the flue is suitable.
The device must be installed in accordance with the current standards of the construction law. The
insert must be set at a safe distance from any flammable products. It may be necessary to protect the
walls and the materials around. The unit must stand on a solid, non-combustible base. The chimney
must be tight, its walls smooth, before connecting, it should be cleaned off soot and contamination.
The connection between the chimney and the insert must be tight and made of non-combustible
14
The provisions contained in them must be observed!
NOTE!
EN