Battery Replacement; Care And Maintenance; Technical Data - Trotec MultiMeasure Basic Manual De Instrucciones

05. Battery replacement

Replace the battery if the display becomes dimmer or if
the acoustic signal becomes quieter.
1. Lift up the battery compartment holder (3) slightly and
push the lid of the battery compartment off in an up-
ward direction.
2. Replace the spent batteries with two new batteries,
ensuring that the polarity is correct.
3. Push the lid back until it clicks into place.

06. Care and maintenance

Clean the device if necessary with a moist, soft, lint-free
cloth. Take care that no moisture enters the housing. Do
not use sprays, solvents, cleaning agents containing al-
cohol or scouring agents; use only clean water to mois-
ten the cloth.

07. Technical data

Detection range . . . . . . . . . . . . . .200 ~ 1000 V AC, 50/60Hz
Overvoltage category: . . . . . . . .CAT III 1000 V, CAT IV 600 V
Degree of fouling: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Battery type: . . . . . . . . . . . . . . . .2 x 1.5 V AAA batteries (micro)
electrical and electronic equipment. Please dispose of this
equipment in accordance with the applicable legal regulati-
ons when its service life is ended.
Operating Manual – Voltage Detector BE 15
Electronic equipment may not be disposed of as
domestic waste, but must be correctly dispo-
sed of in accordance with the EUROPEAN PAR-
LIAMENT AND EUROPEAN COUNCIL Directive
2002/96/EC of 27 January 2003 regarding used
B - 6