Scope Of Delivery - Franke ZAQUA014 Instrucciones De Montaje Y Uso

4. Application
AQUA 3000 open terminating resistor, for bilaterally terminating the system line to
ensure proper data communication.
5.

Scope of Delivery

6. Assembly Instructions
☞
Important!
• The terminating resistor must be installed only when they are in a dead condition.
The terminating resistor is connected to the end of the system line (seen from the
ECC-function controller) to the open connection side of the electric T-junction for the
last electronic module.
6.1 Place the union nut (c) up to the stop on the connection line (b) of the terminating
resistor.
☞
The cable cores are marked with numbers 1 through 4.
6.2 Latch the cable cores (d) into the cable core guides (e) according to their colours.
A: Union nut
B: Connecting resistor
6.3 Cut off the protruding ends of the cable core so that they are flush, i. e. so that they
do not protrude.
6.4 Place the union nut (c) with the connecting line (g) on to the electric T-junction (f)
and tighten with the required torque (1.2 Nm).
Important!
Ensure correct polarity.
Each core cable colour must be in the same cable core guide on both union nuts.
☞
When the union nut is being tightened, the electrical contact and the pull-relief are
automatically established.
Special seals provide protection against dust and water.
4
A
1 brown
2 white
3 blue
4 black
B
red
white
blue
black