Service Information; Troubleshooting - BLACK&DECKER PD400L Manual De Instrucciones

ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or
authorized service center.
WARNING! The use of any accessory not recommended for use with this tool could be
hazardous.

SERVICE INFORMATION

Black & Decker offers a full network of company-owned and authorized service locations.
All Black & Decker Service Centers are staffed with trained personnel to provide customers with
efficient and reliable power tool service. For more information about our authorized service centers
and if you need technical advice, repair, or genuine factory replacement parts, contact the
Black & Decker location nearest you, or visit us at www.BlackandDecker-la.com
SPECIFICATIONS
Screwdriver PD400L
Voltage 3.6V
Speed 180/min
Torque 40in-lbs (4.6Nm)
Charging Time 30h
Charger PD400L
Input
AR 220V ~ 50Hz 30mA
B2C 220V ~ 50-60Hz 30mA
B3 120V ~ 60Hz 5W
BR 127V/220V ~ 50-60Hz 30mA
Output
AR 4V ~ 100mA
B2C 4.5V ~ 80mA
B3 4,2V CA/AC 100mA
BR 4V ~ 100mA
Problem
• Tool will not charge.
PD500C
4.8V
180/min
40in-lbs (4.6Nm)
30h
PD500C
220V ~ 50Hz 10mA
220V ~ 50-60Hz 30mA
120V ~ 60Hz 5W
127V/220V ~ 50-60Hz 30mA
5.8V ~ 40mA
5.8V ~ 40mA
5V CA/AC 100 mA
5.8V ~ 40mA

TROUBLESHOOTING

Possible cause
• Charger not plugged into
a working outlet.
• Surrounding air temperature
too hot or too cold.
27
ENGLISH
Possible Solution
• Plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
• Check current at
receptacle by plugging
in a lamp or other
appliance.
• Check to see if
receptacle is connected
to a light switch which
turns power off when
you turn out the lights.
• Move charger and tool
to a surrounding air
temperature of above
40 degree F (4,5°C)
or below 105 degree
F (+40,5°C).