Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the fastening torque
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjusting
the fastening torque as follows.
1.
First remove the battery cartridge from the tool.
2.
Loosen and remove the screw that secures ring.
3.
Rotate the ring in the front of the tool by hand so
that a hole can be seen below the ring.
4.
Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjusting ring
rotates and becomes visible in the hole. And then
remove the battery cartridge.
5.
Use an optional adjusting grip to adjust the fasten-
ing torque. Insert the pin of the adjusting grip into
the hole in the front of the tool. And then, turn the
adjusting grip clockwise to set a greater fastening
torque, and counterclockwise to set a smaller fas-
tening torque.
1
2
3
3
6.
Align the yellow line with your desired number on
the fastening torque scale.
7.
Insert the battery cartridge and be sure that a fas-
tening torque has been set up by using a fastening
torque tester.
8.
Rotate the ring so that the hole for adjusting grip is
covered, hold and then secure the ring with screw.
NOTE:
•
Numbers on the fastening torque scale is a
guideline to set up your desired fastening torque.
004045
1. Adjusting ring
1
2. Ring
2
004046
1. Adjusting ring
4
2. Ring
3. Scale
4. Adjusting grip
5
5. Hole for adjust-
6
ing grip
6. Yellow line
7. Compression
7
spring
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
12mm(15/32")
9mm(3/8")
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
1
2
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
•
If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
OPERATION
Screwdriving operation
7
001761
004047
1. Bit
2. Sleeve
004048
Publicidad
Tabla de contenido
