Manual Fold Setup; Manual Feeding - Martin Yale 2601 Instrucciones De Uso

GB

4.6 Manual Fold Setup

Setting a standard fold with non-standard size paper
Press the Fold Type key to select the desired type of standard fold.
Press the Paper key until the "Other" indicator lights.
The display will show:
T1
CHG:
Use the or keys to change the dimension shown to the length
of your paper in millimeters. Press Enter and the fold will be setup
automatically.
The display will first show ...
TEMP JOB: 1
SETTING
... then return to the normal running mode display.
Run a trial piece to check the fold. If necessary make corrections as
described on page 12.
Setting a non-standard fold with any size paper
Press the Paper key to select any of the 3 standard paper sizes, or select
"Other" and set the paper size as described above.
Press the Fold Type key to set fold plate 1. Measure the length of the
first fold on your sample and transfer the measurement using the
keys.
Press Fold 2 and transfer the measurement of the second fold. If your
special fold is a single fold, you don't need to set fold plate 2.
Press Enter, the machine will set itself automatically.
Run a trial piece to check the fold. If necessary make corrections as
described on page 10.
Note: the machine's electronic control system will not allow you to
deviate too far from the standard settings. This will prevent jams caused
by "impossible" folds.
PAPER = 297.0
DONE: Enter

4.7 Manual Feeding

The manual feed mode allows you to hand feed sets of 2 or more sheets,
loose, glued or stapled. The limit is 5 sheets of 80 g/m² bond, folded into
a single, letter (C) or Z fold.
DO NOT attempt to fold sets into any other type
of fold. This could result in serious damage to the
machine.
In manual feed mode the fold rollers will be turning but the feeder is
disabled. Automatic feeding is not possible, paper is fed by hand, one
set at a time.
Setting the feeder for manual feed
Press the Manual Feed key. The display will say:
MANUAL FEED MODE?
YES: Enter
Press Enter. You will hear a small motor opening the feeder gap, which
will enable you to feed more than one sheet at a time.
After the motor stops, the display will shows:
MANUAL FEED
Press Start and start feeding your collated sets one by one. In order to
get cleanly folded sets, make sure to insert the sets straight down the
paper guides on the feed table.
or Returning to automatic feed
To get out of the manual feed mode, press the Manual Feed key again.
The display will ask:
MANUAL FEED EXIT?
YES: Enter
Press the Enter key. The display will say:
INSERT ONE SHEET
DONE: Enter
Insert a sheet of paper to be fed automatically and press Enter. The
machine will set the sheet gap to the thickness of the sample sheet and
the display will return to normal running mode.
Remove the sample sheet or press Trial Piece to feed the sheet through
the machine.
30
MARTIN YALE
2601
NO:
READY
123456
NO: