Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 24

Intended Use

This appliance is intended for ironing of clothing and
textiles.
It is intended for use in households.
Any other use shall be considered as not intended use and
can lead to material damage or even personal injury.
Overview of the Components /
Scope of Delivery
1 Lock for continuous steam
2 Steam jet button
3 Temperature control
4 Connecting tube
5 "Temperature" control lamp
6 Base
7 Iron rest
8 Intake hose
9 Water tank
10 Water tank recess
11 Transport lock
Notes for Use
Unpacking
• Remove any protective foils and stickers from the sole
plate.
• Remove the cable from the cable compartment.
Electrical Connection
Make sure that the iron voltage (see name plate) and the
line voltage match.
Power Requirements
The station has a total maximum wattage of 2400 W. With
this connected load a separate supply line protected by a
16 A household circuit breaker is recommended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appliance is
too powerful.
Turn On and Off
Turn on:
Ensure that the temperature control is in the
MIN position. Connect the mains plug to a
properly installed safety socket. The appliance
is immediately switched to operating mode.
Turn off: Ensure that the temperature control is in the
MIN position. Disconnect the mains plug from
the socket.
DBS3749_IM
Temperature Control on the Iron
The symbols on the control correspond to the following
settings:
(synthetics, silk) low temperature
(rayon, wool)
medium temperature
(cotton, linen)
high temperature
• Turn woollen clothes inside out to avoid shiny spots on
the fabric due to steam ironing. In addition, lay a thin
cotton cloth onto the fabric.
• Select a low temperature setting for fabrics with addi-
tional surface treatment and iron them inside out.
NOTE:
The iron heats up faster than it cools down. Start ironing
with the lowest temperature setting.
Lock for Continuous Steam
The lock allows you to generate continuous steam.
= Continuous steam
= Continuous steam off
Water Tank
• The water tank has a recessed grip so that it can be
removed.
• When sliding the tank back into the base, it must audibly
click into place.
• The MAX mark is placed on the water tank. Do not fill the
tank above this mark. The tank volume is 1.2 litres.
Water
CAUTION: Limescale build-up on the appliance!
• Use only distilled water!
If you do not comply with this important note, it may
result in a defective appliance.
• An appliance that is defective due to build-up of limes-
cale shall not be covered by the free warranty.
• Do not fill battery water, water from the clothes dryer
and water containing additives (such as starch, perfume,
softener or other chemicals) into the water reservoir.
• This could damage the iron due to residues forming in
the steam chamber. These residues may cause impu-
rities to the fabric when dropping out of the holes in the
soleplate.
Operation
Before Initial Use
• Clean the ironing base with a slightly damp cloth.
• In order to remove all residues before initial use, please
pass the iron a few times over an old clean cloth.
39
26.09.19

Publicidad

Tabla de contenido
loading

Tabla de contenido