Installation - Edesa HC1 Serie Manual De Instrucciones

UNPACKING
Carefully remove all the elements
protecting the apparatus. The two
brackets "A" in two parts of the
oven must also be removed, as
shown in the figure.
OVEN WITH FIXED HOT PLATE CONTROLS
The unit´s measurements are as
shown in the drawning.
The hot plate unit should be
installed first and left
disconnected until the oven is
installed. (See hot plate
instruction manual).
It is very important to maintain the
ventilation holes for the correct
operation of the oven.
Lift the hot plate straps and cable
when installing the oven into the
unit, leaving sufficient room to
house the straps onto the knob
shafts, screw them into place and fit
cable to the connector.
Push the oven fully home and support
the unit with 4 screws. (In oven
accesories bag)
Press-fit the controls accesories,
according to the type of heat
source (in stove-top/oven
accessories bag or in both).
Then fit the knobs (in oven
accessories bag).

INSTALLATION

76
A