Instructions Of Use; Lubrification - BEAUTY JATA MP34B Instrucciones De Uso

device (DDR) of differential current of assigned capacity that
does not exceed 30 mA. Ask your supplier for advice.
• Suitable for cleaning under the tap.
• Suitable for using in the bath or in the shower.
• The adapter must always be used indoors. Do not use in the
open air.
• The cleaning and maintenance done by users, can not be done
by children without any supervision.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel in order to avoid a danger.
• If there is any nylon filament found on the blades, it's
due to the quality control made in each unit.

INSTRUCTIONS OF USE

Charging the battery.
• Before using it for the first time it is necessary to charge the battery.
• To do so keep the switch (5) on "0FF" position, connect the adapter terminal in the lower part of the appliance
and the adapter (6) to the mains.
• For the first charge leave it connected during 2 hours. The pilot light will be on until the charge is finished. To
use the appliance, remove the adaptor. The battery works around 60 minutes.
• In order to optimise the durability of the battery bear in mind the following pieces of advice:
- Never exceed the indicated loading times for the battery.
- It is important to discharge the battery before it is recharged, leave it on until it stops or the power
decreases clearly.
- The battery must be recharged every 6 months if it has not been used for said period of time.
- Also recharge if it has not been used for more than a month.
TO PLACE THE ACESSORIES
• The following accessories: body trimmer (2), the nose (4), the rotary shaver (1) and the blade (3) are placed in
the main units by fixing and with a slightly pressure.
• To remove them, pull them upwards carefully.

LUBRIFICATION

• For the hair clipper to work correctly it is absolutely necessary to lubricate the blades with oil before each
use.
• Carefully pour a few drops of oil, which is provided, between the teeth of the blade, or if you have run out, with
another high quality, acid free oil.
• Turn the hair clipper on for a few seconds and clean the excess oil off with a cloth.
CUTTING GUIDES
• The hair clipper is equipped with a cutting guide (7) which allows for an accurate height of cutting in 2
different lengths (0 - 10 mm.) by turning the wheel to adjust the different lengths.
• Place the guide in the blade (3) and press it with the finger to leave it correctly fixed.
12